From: BIKEMAN (krode@xxxxxxxxxxx)
Date: Tue Apr 17 2001 - 08:37:43 GMT-3
Hi Saleem
I cut the switch type. In Australia we don't do spids...
Rudi
----- Original Message -----
From: "Sal Nathoo" <snathoo2001@yahoo.com>
To: "BIKEMAN" <krode@bigpond.com>; <ccielab@groupstudy.com>
Sent: Tuesday, April 17, 2001 9:19 PM
Subject: Re: ISDN Backup Interface
> Hi,
>
> I do not see the proper entries for ISDN setup.
>
> Global config
> isdn switch-type ???
>
> Interface config
> isdn spid1 ???????? ???????
> isdn spid2 ???????? ???????
>
> If you take the backup statement out. Can you check
> the layer 1 & 2 settings for isdn. show isdn status??
>
> Hope this helps.
>
> Thanks,
> Saleem
>
>
> --- BIKEMAN <krode@bigpond.com> wrote:
> > Hi all
> >
> > I am playing with backup interfaces and can't get it
> > to work. Below is the
> > configs, debugs and show that I have tried. What I
> > don't understand is why the
> > BRI goes to deactivated instead of active. Any ideas
> > ?
> >
> > Config R3 :
> >
> > interface Serial1
> > backup delay 3 3
> > backup interface BRI0
> > backup load 50 25
> > ip address 10.0.3.2 255.255.255.0
> > no ip directed-broadcast
> > shutdown
> > clockrate 250000
> >
> > interface BRI0
> > ip address 10.0.2.2 255.255.255.0
> > no ip directed-broadcast
> > encapsulation ppp
> > dialer map ip 10.0.2.1 name R2 broadcast 95717183
> > dialer-group 1
> > isdn switch-type basic-net3
> > isdn answer2 123
> > ppp callback request
> > ppp authentication chap
> >
> > When I do show backup with S1 active:
> >
> > R3#sh backup
> > Primary Interface Secondary Interface Status
> > ----------------- ------------------- ------
> > Serial1 BRI0 normal
> > operation
> >
> > Now I disable S1 and get the following from "debug
> > backup" :
> >
> > R3(config)#int s1
> > R3(config-if)#shut
> > R3(config-if)#
> > 01:14:24: BACKUP(Serial1): event = interface
> > shutdown
> > 01:14:24: BACKUP(Serial1): secondary interface
> > (BRI0) moved to standby
> > 01:14:24: BACKUP(Serial1): changed state to
> > "disabled"
> > 01:14:26: %LINK-5-CHANGED: Interface Serial1,
> > changed state to
> > administratively
> > down
> > 01:14:27: %LINEPROTO-5-UPDOWN: Line protocol on
> > Interface Serial1, changed
> > state
> > to down
> >
> > and "show backup" :
> >
> > Primary Interface Secondary Interface Status
> > ----------------- ------------------- ------
> > Serial1 BRI0 disabled
> >
> >
> > Thanks in advance
> >
> > Rudi
> > **Please
> > read:http://www.groupstudy.com/list/posting.html
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:47 GMT-3