From: Haohong Lin (hhlin@xxxxxxxxxx)
Date: Fri Apr 13 2001 - 00:27:59 GMT-3
When I setup full mesh frame relay map topology, everything works.
I still puzzle why ip nbma network can do but ipx network not.
-----Original Message-----
From: Michel Gaspard [mailto:mgaspard@cisco.com]
Sent: 2001 04 12 21:06
To: hhlin@szskzj.com
Cc: ccielab@groupstudy.com
Subject: Re: IPX over Frame Relay
Lin,
What do you mean exaclty with "ping from one spoke router to another's
ehternet IP"
Do you mean IPX pings, or IP pings?
The fact that IPX routing is OK has no influence on the IP routing,
unfortunately...
Otherwise (IPX pinmgs), could you send your config?
Try also to map the other spoke router's IPX address to DLCi on the
interfaces.
Check the IPX routing table for these destinations.
Regards,
Michel
> From nobody@groupstudy.com Thu Apr 12 14:52:13 2001
> From: "Haohong Lin" <hhlin@szskzj.com>
> To: "CCIELab" <ccielab@groupstudy.com>
> Subject: IPX over Frame Relay
> Date: Thu, 12 Apr 2001 20:50:33 +0800
> Sender: nobody@groupstudy.com
> Reply-To: "Haohong Lin" <hhlin@szskzj.com>
>
> Hi,
>
> When I using EIGRP as IPX routing protocol on Frame Relay network,
every
> ipx routes seemed fine after disabled IPX split-horizon on hub router. But
I
> tried to ping from one spoke router to another's ehternet IP, packets
> stoped on hub router's serial interface. How can I resolve this problem?
>
>
> Haohong Lin
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:45 GMT-3