From: Curtis Call (curtiscall@xxxxxxxx)
Date: Fri Apr 13 2001 - 11:52:36 GMT-3
Why don't you post your configs? I don't remember seeing them.
At 09:27 PM 4/12/01, you wrote:
>When I setup full mesh frame relay map topology, everything works.
>I still puzzle why ip nbma network can do but ipx network not.
>
>-----Original Message-----
>From: Michel Gaspard [mailto:mgaspard@cisco.com]
>Sent: 2001 04 12 21:06
>To: hhlin@szskzj.com
>Cc: ccielab@groupstudy.com
>Subject: Re: IPX over Frame Relay
>
>
>Lin,
>
>What do you mean exaclty with "ping from one spoke router to another's
>ehternet IP"
>
>Do you mean IPX pings, or IP pings?
>
>The fact that IPX routing is OK has no influence on the IP routing,
>unfortunately...
>
>
>Otherwise (IPX pinmgs), could you send your config?
>
>Try also to map the other spoke router's IPX address to DLCi on the
>interfaces.
>
>Check the IPX routing table for these destinations.
>
>Regards,
>
>Michel
>
> > From nobody@groupstudy.com Thu Apr 12 14:52:13 2001
> > From: "Haohong Lin" <hhlin@szskzj.com>
> > To: "CCIELab" <ccielab@groupstudy.com>
> > Subject: IPX over Frame Relay
> > Date: Thu, 12 Apr 2001 20:50:33 +0800
> > Sender: nobody@groupstudy.com
> > Reply-To: "Haohong Lin" <hhlin@szskzj.com>
> >
> > Hi,
> >
> > When I using EIGRP as IPX routing protocol on Frame Relay network,
>every
> > ipx routes seemed fine after disabled IPX split-horizon on hub router. But
>I
> > tried to ping from one spoke router to another's ehternet IP, packets
> > stoped on hub router's serial interface. How can I resolve this problem?
> >
> >
> > Haohong Lin
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:45 GMT-3