FATKID 330 #4

From: Perry Jannette (perry.jannette@xxxxxxx)
Date: Sun Apr 08 2001 - 22:41:56 GMT-3

• Next message: Alan Basinger: "RE: Off Topic - from the mouths of babes"
• Previous message: . ..: "Re: spid1 sent, spid1 not valid - but the line works???"
• Next in thread: Mohamed Heeba: "RE: FATKID 330 #4"
• Maybe reply: Mohamed Heeba: "RE: FATKID 330 #4"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
I am doing Fatkid lab 330 and I can't figure out how to do step #4. Step 4 is
listed below.

"Configure R4 so that it's IPX node address is 4444, as seen by R1 and R2.
The Term_Srv router should still see the default node address."

I know how to change the default node address, but that changes it for the
whole router. I am assuming there is an interface command that can change the
default node address on the way out???

Perry

• Next message: Alan Basinger: "RE: Off Topic - from the mouths of babes"
• Previous message: . ..: "Re: spid1 sent, spid1 not valid - but the line works???"
• Next in thread: Mohamed Heeba: "RE: FATKID 330 #4"
• Maybe reply: Mohamed Heeba: "RE: FATKID 330 #4"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:42 GMT-3