From: Mohamed Heeba (MAHeeba@xxxxxxxxxxx)
Date: Mon Apr 09 2001 - 00:38:29 GMT-3
perry ;
the command is
interface e0
mac-address 0000.0000.4444
notice that the command
ipx routing 0000.0000.0001
will only affect the node addresses for interfaces like serial and loopback
which has no mac-address defined ,while in ethernet the node address will
remain the same unless u change it with the mac-address command .
Mohamed
-----Original Message-----
From: Perry Jannette [mailto:perry.jannette@usa.net]
Sent: Monday, April 09, 2001 5:42 AM
To: ccielab
Subject: FATKID 330 #4
I am doing Fatkid lab 330 and I can't figure out how to do step #4. Step 4
is
listed below.
"Configure R4 so that it's IPX node address is 4444, as seen by R1 and R2.
The Term_Srv router should still see the default node address."
I know how to change the default node address, but that changes it for the
whole router. I am assuming there is an interface command that can change
the
default node address on the way out???
Perry
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:42 GMT-3