From: MASK (afaqk@xxxxxxxxxxxxxx)
Date: Mon Feb 26 2001 - 19:27:19 GMT-3
is nvram is part of flash, i mean i dont belive that
it is in hardware a single Intregrated ckt, probably
both are EEPROM, but in separate chips.
thx
--- frank wells <fwells12@hotmail.com> wrote:
> My bad. Try taking the flash out and putting it in
> another 2500 series
> router. Perform previous instructions on it then
> transfer it back to the
> original router with a working aux port. The
> startup config is saved on the
> flash (nvram) I believe, so you may find this will
> work.
>
>
> >From: MASK <afaqk@rocketmail.com>
> >Reply-To: MASK <afaqk@rocketmail.com>
> >To: frank wells <fwells12@hotmail.com>,
> ccielab@groupstudy.com
> >Subject: Re: challenge q
> >Date: Mon, 26 Feb 2001 13:06:57 -0800 (PST)
> >
> >hi,
> >
> >i cant go to the ROMMON mode, cause it doesn't
> allow
> >to break(ctl-brk) via AUX port, only via CON port.
> >
> >i think my router has "no enable password" and/or
> "no
> >enable secret", thats why when i log-in via AUX,
> and
> >type "en", it says "%No Password Set".
> >
> >bbye
> >
> >--- frank wells <fwells12@hotmail.com> wrote:
> > > Reboot the router and get to ROMMON. Change the
> > > config register to 0x2142.
> > > Reload the router, it will boot normally but it
> will
> > > not start the startup
> > > script. Log on as normal. Go to 'line aux 0'
> and
> > > type in 'transport input
> > > all', 'modem inout', 'login' and password xxxx'
> Once
> > > you have done that,
> > > change the config register back to 0x2102 and
> reboot
> > > it again. Make sure
> > > you have are plugged into the aux port with your
> > > terminal emulation program.
> > > You will now have access to the router just
> like
> > > over the console port.
> > >
> > >
> > >
> > >
> > > >From: MASK <afaqk@rocketmail.com>
> > > >Reply-To: MASK <afaqk@rocketmail.com>
> > > >To: ccielab@groupstudy.com
> > > >Subject: challenge q
> > > >Date: Mon, 26 Feb 2001 12:25:45 -0800 (PST)
> > > >
> > > >hi,
> > > >
> > > >I've a router (2501), whose Console port is
> faulty,
> > > >and its AUX port has an unknown password set
> onto
> > > it,
> > > >and to make the matter worse its all interfaces
> are
> > > >shut down, so we cant even telnet to it!!
> > > >
> > > >anyone has got any clue??? how can i make this
> > > router
> > > >usable?
> > > >
> > > >i know many gr8 minds are on this list!!
> > > >
> > > >thanks
> > > >
> > >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:29:04 GMT-3