From: Larry Roberts (lroberts22@xxxxxxxxxx)
Date: Thu Feb 22 2001 - 00:04:05 GMT-3
I usually just set everything to 64000.
-Larry R
----- Original Message -----
From: "perez claude-vincent" <claude_vincent@yahoo.com>
To: <Piperw222@aol.com>; <ccielab@groupstudy.com>
Sent: Wednesday, February 21, 2001 7:38 PM
Subject: Re: bootcamp - switch configuration for lab 8
> Hi,
>
> If the match speed is not required by the scenario,
> just don't care of it (none of the bootcamp scenarios
> require it).
>
> If you cannot use the speed indicated in the scenario,
> just be careful of your metrics in the routing table
> that should be meaningful.
>
>
> --- Piperw222@aol.com wrote:
> > Can someone please tell me whether the clock speeds
> > on the switch have to
> > match with the low speed and high speed interface -
> > when you have dlci's
> > mapped to between high speed and low speed int The
> > problem that I am having
> > is that the high speed interface allow you to use
> > 115200 but the low speed
> > int don't have a matching speed -- so I would have
> > to configure them both
> > with 64000. What I really want to know is ,if it has
> > to match or not and if
> > yes what is the best speed to use. I would also like
> > to know if the router
> > that is connected to the switch has a dce interface
> > and the interface on the
> > switch is dte what is the best clock speed to use on
> > the router... The norm
> > is usually 2000000 So again my question is do the
> > speeds have to match... I
> > am going to be using rack #2 on bootcamp.. If
> > anyone can help me with the
> > switch configuration for lab 8 I would be greatly
> > appreciated.. I have killed
> > a lot of time in the past getting frame relay to be
> > stable...
> >
> >
> > Thanks
> >
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:56 GMT-3