From: Chuck Larrieu (chuck@xxxxxxxxxxxxx)
Date: Tue Feb 20 2001 - 15:39:40 GMT-3
Nothing special needed other than what you mention
Sample I completed recently - worked fine:
NTP server config
----------------------
ntp master
NTP client config
----------------------
ntp server 137.20.20.1
does take about 10 minutes or so to synch. did you set the correct time and
date on the server? Clock set command?
Chuck
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
sanjay
Sent: Tuesday, February 20, 2001 10:29 AM
To: ccielab@groupstudy.com
Subject: NTP Configuration
Is there any special commands to configure NTP across Frame Relay. One =
of my routers is set as an NTP Master and I have NTP Broadcast command =
setup on the serial interface that goes to the Frame cloud. The other =
router is setup as NTP Server with the NTP Masters IP address and also =
has the NTP Broadcast client command . The clock won't sync. I have =
turned the interface on/off, but it still won't sync. It has been over =
24 hours since I configured it. Any ideas ??
thanks,
Sanjay
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:54 GMT-3