From: Hardin Les - SMTP (hardinl@xxxxxxx)
Date: Mon Feb 19 2001 - 18:30:49 GMT-3
Dan,
Have you check this link out? http://www.cisco.com/warp/public/125/21.shtml
Les
At 03:34 PM 2/19/2001 -0500, Dan wrote:
>When in map-class configuration mode, I have a question about the
>"frame-relay be" command.
>I know that I must put in a number (in bits) after "frame-relay be" which
>according to the doc CD is the "excess-burst-size."
>To me this means I must put in the difference between bc and be, and not
>bc+be. Am I correct?
>
>For example, assuming that Tc is 125ms and I have a CIR of 48K burstable=
to
>64K, I would configure my map-class as follows:
>
>r2(config)#map-class frame-relay myclass
>r2(config-map-class)frame-relay cir 48000
>r2(config-map-class)frame-relay bc 6000
>r2(config-map-class)frame-relay be 2000
>
>Is this correct?
>
>Also, I noticed there is another command I can use in map-class config=
mode:
>"frame-relay traffic-rate 48000 64000"
>Does this command accomplish the same thing?
>
>Thanks for your input.
>
>Dan Pontrelli
>Customer Installation Engineer - Verio NYC
>CCNP, MCSE, CNA
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:28:53 GMT-3