From: Tomohiro Yoshizawa (yoshizawa_t@xxxxxxxxx)
Date: Mon Jan 29 2001 - 13:46:46 GMT-3
Hi everyone!
I have one 2524 and one 2525, each has only one 4-wire
56k CSU/DSU module. I want to conneto both two routers
each other, so I used Cisco rolled RJ-45 cable to
connet them. Then I input the following command at
each routers.
*************
interface serial 0
no shutdown
ip address 200.1.1.1 / 200.1.1.2
service-module 56k clock rate 56
***************************
After I input these command, the line became up for a
while. I checke "show ip route" and it showed the
direct connection. But it changed to down in a few
second. I don't know why. Could you give me some
advice? Thanks.
Tomohiro
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:47 GMT-3