From: Mike Schlenger (mschlenger@xxxxxxxxxxxxxxxx)
Date: Tue Jan 23 2001 - 12:29:01 GMT-3
I configured a netbios SAP filter to only allow netbios only. When I type
"access-list 201 permit 0x0f0f 0x0101" it shows up in the config as 0x0E0E
0x0101. Is this a problem? Am I missing something?
Check the config below:
p subnet-zero
ip tcp synwait-time 5
no ip domain-lookup
ipx routing 0000.0000.0003
ipx eigrp-sap-split-horizon
!
source-bridge ring-group 1
dlsw local-peer peer-id 170.100.243.1 promiscuous
dlsw remote-peer 0 tcp 170.100.244.1 lsap-output-list 201
!
!
access-list 201 permit 0x0E0E 0x0101
!
interface TokenRing0
ip address 170.100.51.33 255.255.255.0
ip access-group 101 in
no ip directed-broadcast
ipx network 302
ring-speed 16
source-bridge 3 1 1
source-bridge spanning
Michael Schlenger
Consulting Engineer
N2N Solutions
mschlenger@n2nsolutions.com
cell: 847.452.6246
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:40 GMT-3