From: Atif Awan (atifawan@xxxxxxxxxxx)
Date: Tue Jan 23 2001 - 15:54:51 GMT-3
For netbios you need to use :
access-list 200 permit 0xF0F0 0x0101
>From: Mike Schlenger <mschlenger@n2nsolutions.com>
>Reply-To: Mike Schlenger <mschlenger@n2nsolutions.com>
>To: "'ccielab@groupstudy.com'" <ccielab@groupstudy.com>
>Subject: Netbios filter question
>Date: Tue, 23 Jan 2001 09:29:01 -0600
>
>I configured a netbios SAP filter to only allow netbios only. When I type
>"access-list 201 permit 0x0f0f 0x0101" it shows up in the config as 0x0E0E
>0x0101. Is this a problem? Am I missing something?
>
>Check the config below:
>
>p subnet-zero
>ip tcp synwait-time 5
>no ip domain-lookup
>ipx routing 0000.0000.0003
>ipx eigrp-sap-split-horizon
>!
>source-bridge ring-group 1
>dlsw local-peer peer-id 170.100.243.1 promiscuous
>dlsw remote-peer 0 tcp 170.100.244.1 lsap-output-list 201
>!
>!
>access-list 201 permit 0x0E0E 0x0101
>!
>interface TokenRing0
> ip address 170.100.51.33 255.255.255.0
> ip access-group 101 in
> no ip directed-broadcast
> ipx network 302
> ring-speed 16
> source-bridge 3 1 1
> source-bridge spanning
>
>
>Michael Schlenger
>Consulting Engineer
>N2N Solutions
>mschlenger@n2nsolutions.com
>cell: 847.452.6246
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:40 GMT-3