From: Chuck Larrieu (chuck@xxxxxxxxxxxxx)
Date: Sun Jan 21 2001 - 00:59:09 GMT-3
The clock rate command goes on the interface to which is attached the DCE
end of the cable.
This does NOT have to be the same as the interface which is configured with
the frame-relay interface-type DCE command.
HTH
Chuck
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com] On Behalf Of
Kevin Mahoney
Sent: Saturday, January 20, 2001 7:54 PM
To: CCIE_Lab Group Study
Subject: RE: Router as frame switch
Did you put frame-relay interface-type dce on the interface?
Kevin
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Ken Vandenbark
Sent: Saturday, January 20, 2001 10:41 PM
To: CCIE_Lab Group Study
Subject: Router as frame switch
Hello!
=20
In attempt to configure a 2511 as a frame switch to two other routers I
enter in clock rate 64000 on s0 and it will not show up on the config.
Has anyone ever seen this? Running IOS 11.2 (19a) I can enter clock =
rate
on s1 and it will show up on running config.
Ideas?
kv
=20
=20
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:37 GMT-3