From: Robert DeVito (robertdevito@xxxxxxxxxxx)
Date: Thu Jan 18 2001 - 18:58:53 GMT-3
I beleive if your router is connected to the Cat5, you have to configure the
ethernet port of your router and the connecting port on the cat5 for cgmp.
Thoughts?
Robert
----Original Message Follows----
From: Patrick Bikar <pbikar@cisco.com>
Reply-To: Patrick Bikar <pbikar@cisco.com>
To: Joe Thelander <jtheland@cisco.com>, ccielab@groupstudy.com
Subject: Re: Multicast help
Date: Thu, 18 Jan 2001 16:53:09 +0000
For 1., just ping a multicast address
At 23:07 17/01/2001 -0800, Joe Thelander wrote:
>
>>Hi,
>>
>>I have a two question about multicast that I hope you can help me with.
>>
>>1. I can set up routers to do multicast routing, no problem, however I
don't
>>know how to to verify correct operation. Only thing I've been able to
come
>>up with is to put an "ip igmp join-group" command on an interface, which
>>kind of simulates a workstation joining the group. I haven't found a way
>>to use a router to simulate a multicast sender. What is the preferred
>>method to simulate senders and receivers using only routers?
>>
>>2. If the test doesn't specifically mention cgmp are you still required
>>to set cgmp up between the catalyst and the routers, i.e.
>
>
>On the Catalyst:
>set cgmp multicast enable
>set multicast router module/port
>set cgmp leave enable
>
>On the router
>int e0
>ip cgmp
>
>
>
>>thx,
>>-Joe
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:34 GMT-3