From: G F Marsh (gfm@xxxxxxxxx)
Date: Sat Jan 13 2001 - 14:06:25 GMT-3
Are you using the right IOS version?
Should be enterprise versions for frame switch, I think.
GFM
----- Original Message -----
From: Jason Whelan <Jasonw@logic.bm>
To: <ccielab@groupstudy.com>
Sent: Saturday, January 13, 2001 4:37 PM
Subject: Frame relay switch problem
> Hi All,
> Since I don't have a router with 4 serial int, I want to set up two
routers
> as a frame switch for mesh connectivity.
> I have seen an article describing using a tunnel between two 2501's which
> basically aggregates the two routers into one 4 port frame switch.
> Problem is, when I config the routers interface frame-relay route
statments,
> ie frame-relay route 200 interface tunnel0 250, the router doesn't like
the
> command.
> I am not using two 2501's, but a 3810 to a 2514.
> Is this the problem?
> I am sure someone out there has run into this problem.
> Cheers
> Jason
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:28 GMT-3