From: David Ankers (d.ankers@xxxxxxxxx)
Date: Sat Jan 13 2001 - 17:41:20 GMT-3
Frame-switch is availible on IP BUT frame switching over tunnels is
enterprise.
On Saturday 13 January 2001 17:06, you wrote:
> Are you using the right IOS version?
> Should be enterprise versions for frame switch, I think.
>
> GFM
> ----- Original Message -----
> From: Jason Whelan <Jasonw@logic.bm>
> To: <ccielab@groupstudy.com>
> Sent: Saturday, January 13, 2001 4:37 PM
> Subject: Frame relay switch problem
>
> > Hi All,
> > Since I don't have a router with 4 serial int, I want to set up two
>
> routers
>
> > as a frame switch for mesh connectivity.
> > I have seen an article describing using a tunnel between two 2501's which
> > basically aggregates the two routers into one 4 port frame switch.
> > Problem is, when I config the routers interface frame-relay route
>
> statments,
>
> > ie frame-relay route 200 interface tunnel0 250, the router doesn't like
>
> the
>
> > command.
> > I am not using two 2501's, but a 3810 to a 2514.
> > Is this the problem?
> > I am sure someone out there has run into this problem.
> > Cheers
> > Jason
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:28 GMT-3