From: Jason Whelan (Jasonw@xxxxxxxx)
Date: Sat Jan 13 2001 - 13:37:06 GMT-3
Hi All,
Since I don't have a router with 4 serial int, I want to set up two routers
as a frame switch for mesh connectivity.
I have seen an article describing using a tunnel between two 2501's which
basically aggregates the two routers into one 4 port frame switch.
Problem is, when I config the routers interface frame-relay route statments,
ie frame-relay route 200 interface tunnel0 250, the router doesn't like the
command.
I am not using two 2501's, but a 3810 to a 2514.
Is this the problem?
I am sure someone out there has run into this problem.
Cheers
Jason
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 10:27:28 GMT-3