From: Bays John (bays_john@xxxxxxx)
Date: Wed Dec 27 2000 - 18:23:44 GMT-3
Julie Ann,
I played with the OSPF configuration mentioned last night, and compiled
the same results; and I don't have an answer except that ip ospf network
broadcast on the point-to-multipoint frame interface (and it's
connections) does not have this issue (and hense fits the requirement of
a single area range entry to other OSPF areas -- without the host routes).
John
Jan 8,9 - Halifax
Connary, Julie Ann wrote:
> Hi Chuck,
>
> here is is the config for one router and the table and the sho ip ospf
> database router (if I put more in this email it just bounces back).
> The scenario says to summarize all routes at the ospf border routers so
> that only "one" route to an area appears in the routing table.
> I've successfully done that by using the area x range xxxx xxxx command for
> all but these frame relay interfaces. As you can see in
> the routing table - there is only one route to any IA entry.
>
> Thanks,
>
> Julie Ann
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:26:11 GMT-3