From: Aaron K. Dixon (adixon@xxxxxxxxxxxxxxxxxxxxx)
Date: Mon Dec 18 2000 - 01:11:46 GMT-3
If you want to limit what netbios services that you ADVERTISE use:
dlsw icanreach netbios-name <service name>
If you want ONLY the netbios-name's that you configure with the icanreach
command then add:
dlsw icanreach netbios-exclusive
Regards,
Aaron K. Dixon
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Ronnie Royston
Sent: Sunday, December 17, 2000 7:39 PM
To: ccielab@groupstudy.com
Subject: NETBIOS Filtering by Letter Pattern
Will the below config allow the router to only allow NETBIOS names that
contain the letters CISCO to be advertised to its peer?
netbios access-list host CISCO_PERMIT permit CISCO
!
ip subnet-zero
no ip domain-lookup
!
bridge crb
!
source-bridge ring-group 111
dlsw local-peer peer-id 172.17.59.65
dlsw remote-peer 0 tcp 172.17.59.97 host-netbios-out CISCO_PERMIT
dlsw bridge-group 11
!
!
interface Ethernet0
ip address 172.17.59.65 255.255.255.240
no ip directed-broadcast
media-type 10BaseT
bridge-group 11
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:26:04 GMT-3