From: Farnoosh Bahram (fbahram@xxxxxxxxx)
Date: Sun Dec 17 2000 - 22:36:32 GMT-3
Shahzad-
When you pick up the phone on one port, are you trying to terminate it on
another port? Does the port go offhook? Do we receive the digits to send to
the other port?
Try using these debugs:
To see port activity:-> debug vpm all
To see dial-peer matching (even though mostly used when you have a voip
call-leg)--> debug voip ccapi inout
Also do a -> show voice port 1/0/0 or 1/0/1 after you pick it up. See that it
goes to UP/UP from UP/IDLE.
Let me know if this helps.
Thanks!
Farnoosh
+--------------------------------------------------------------+
Cisco Systems, "The Network Works, No Excuses"
On Sun, 17 Dec 2000, ShahzaD Ali wrote:
->
->Need advise configuring two phone on one router both are attached to port
->1/0//0 and 1/0/1 on Cisco 2620. I can hear the dial tone but when i try to
->dial the # It goes dead. (no tone, no voice). My voip on two different
->routers works fine. Here is the config
->
->
->!
->voice-port 1/0/0
->!
->voice-port 1/0/1
->!
->!
->dial-peer voice 1 pots
-> destination-pattern 1111
-> port 1/0/0
->!
->dial-peer voice 2 pots
-> destination-pattern 2222
-> port 1/0/1
->!
->
->
->Thanks in Advance
->
->
->Regards,
->
->ShahzaD
->
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:26:04 GMT-3