VOIP Configuration

From: ShahzaD Ali (shahzad-ali@xxxxxxxx)
Date: Sun Dec 17 2000 - 19:02:41 GMT-3

• Next message: Claudio Laurentino Da Silva: "md110 configuration for qsig"
• Previous message: Andrew Lennon: "RE: allowing DLSW through an access-list"
• Next in thread: Farnoosh Bahram: "Re: VOIP Configuration"
• Maybe reply: Farnoosh Bahram: "Re: VOIP Configuration"
• Maybe reply: BUI, TIN T (SBCSI): "RE: VOIP Configuration"
• Maybe reply: C. Warren: "Re: VOIP Configuration"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

Need advise configuring two phone on one router both are attached to port
1/0//0 and 1/0/1 on Cisco 2620. I can hear the dial tone but when i try to
dial the # It goes dead. (no tone, no voice). My voip on two different
routers works fine. Here is the config

!
voice-port 1/0/0
!
voice-port 1/0/1
!
!
dial-peer voice 1 pots
 destination-pattern 1111
 port 1/0/0
!
dial-peer voice 2 pots
 destination-pattern 2222
 port 1/0/1
!

Thanks in Advance

Regards,

ShahzaD

• Next message: Claudio Laurentino Da Silva: "md110 configuration for qsig"
• Previous message: Andrew Lennon: "RE: allowing DLSW through an access-list"
• Next in thread: Farnoosh Bahram: "Re: VOIP Configuration"
• Maybe reply: Farnoosh Bahram: "Re: VOIP Configuration"
• Maybe reply: BUI, TIN T (SBCSI): "RE: VOIP Configuration"
• Maybe reply: C. Warren: "Re: VOIP Configuration"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:26:03 GMT-3