From: BUI, TIN T (SBCSI) (tb4565@xxxxxxx)
Date: Mon Dec 18 2000 - 14:31:34 GMT-3
Try the following:
RouterA:
Voice-port 1/0/0
!
Voice-port 1/0/1
!
dial-peer voice 10 pots
destination-pattern 1111
port 1/0/0
dial-peer voice 20 voip
destination-pattern 222.
Session-target ipv4:10.2.2.2
Dial-peer voice 30 pots
Destination-pattern 2222
Port 1/0/1
Dial-peer voice 40 voip
Destination-pattern 111.
Session-target ipv4:10.1.1.1
> Tin T. Bui
> Senior Network Manager
> Network Management Center
> SBC Services Inc.
> 7337 Trade Street, Rm 1110
> San Diego, Ca 92121
> Office #: 858-886-4589
> Pager #: 858-494-0482
> Fax #: 858-549-4103
> Email: tb4565@sbc.com
>
-----Original Message-----
From: ShahzaD Ali [mailto:shahzad-ali@home.com]
Sent: Sunday, December 17, 2000 2:03 PM
To: ccielab@groupstudy.com
Subject: VOIP Configuration
Need advise configuring two phone on one router both are attached to port
1/0//0 and 1/0/1 on Cisco 2620. I can hear the dial tone but when i try to
dial the # It goes dead. (no tone, no voice). My voip on two different
routers works fine. Here is the config
!
voice-port 1/0/0
!
voice-port 1/0/1
!
!
dial-peer voice 1 pots
destination-pattern 1111
port 1/0/0
!
dial-peer voice 2 pots
destination-pattern 2222
port 1/0/1
!
Thanks in Advance
Regards,
ShahzaD
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:26:05 GMT-3