From: Justin Menga (Justin.Menga@xxxxxxxxxxxxxxxxxx)
Date: Mon Dec 11 2000 - 16:51:04 GMT-3
Hi,
With the 'no appletalk send-rtmps', the serial interface does NOT go down -
I have tested this over HDLC, PPP and Frame - no routes are exchanged but
you can still ping each other......
The tunnel interface is a creative solution - but - would this be allowed in
the actual lab if the goal was to configure appletalk for each interface on
a router and advertise them?
Regards,
Justin Menga MCSE+I CCNP CCSE ASE
WAN Specialist
Computerland New Zealand
PO Box 3631, Auckland
DDI: (+64) 9 360 4864 Mobile: (+64) 25 349 599
mailto: justin.menga@computerland.co.nz
-----Original Message-----
From: Tony Olzak [mailto:aolzak@buckeye-express.com]
Sent: Monday, 11 December 2000 2:54 p.m.
To: Justin Menga; ccielab@groupstudy.com
Subject: Re: Appletalk on Serial Interfaces
I finally figured out the answer to this scenario.
R1------R2--------R3--Ethernet
If R3 has an Ethernet segment that you do not want advertised to the rest of
the network, but you can't use filtering, most people say to use "no apple
send-rtmps".
The problem with this command on a serial interface is that the interface
will go down in appletalk and then you won't be able to apple ping the rest
of the network.
The solution is to create a GRE tunnel between R2 and R3 and only configure
appletalk on this interface, not the serial interface. Then use the command
"no apple send-rtmps" on the tunnel interface on R3. This will not bring
down the appletalk protocol and it will not send any RTMP updates about the
ethernet segment attached to the router.
Tony
----- Original Message -----
From: "Justin Menga" <Justin.Menga@computerland.co.nz>
To: <ccielab@groupstudy.com>
Sent: Sunday, December 10, 2000 12:44 AM
Subject: Appletalk on Serial Interfaces
> Hi,
>
> If you have for example a frame-relay cloud with an attached router that
is
> configured for Appletalk, and all other attached routers are NOT
configured
> for Appletalk, I have found that this serial appletalk interface will not
> come up and therefore not be in the routing table.
>
> Does anyone know how to force the serial interface up? If you have
> appletalk running on an Ethernet interface, this will come up even if it
is
> the only
> appletalk device.
>
> I have tried using the appletalk ignore-verify-errors command, but this
does
> not work.
>
> Regards,
>
> Justin Menga MCSE+I CCNP CCSE ASE
> WAN Specialist
> Computerland New Zealand
> PO Box 3631, Auckland
> DDI: (+64) 9 360 4864 Mobile: (+64) 25 349 599
> mailto: justin.menga@computerland.co.nz
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:26:01 GMT-3