From: Justin Menga (Justin.Menga@xxxxxxxxxxxxxxxxxx)
Date: Mon Dec 11 2000 - 16:48:15 GMT-3
Hi,
I could only get it going with SAP - SNAP didn't work.....
Regards,
Justin Menga MCSE+I CCNP CCSE ASE
WAN Specialist
Computerland New Zealand
PO Box 3631, Auckland
DDI: (+64) 9 360 4864 Mobile: (+64) 25 349 599
mailto: justin.menga@computerland.co.nz
-----Original Message-----
From: Mark Beck [mailto:mabeck@cisco.com]
Sent: Monday, 11 December 2000 10:52 p.m.
To: Ronnie Royston; ccielab@groupstudy.com
Subject: RE: DLSW and IPX
I had an issue with getting ipx working over dlsw. The response from the de
is
related here as well:
Most likely it will not work and we can't make it work. As you
said, DLSw+ is for SNA and NetBIOS - all other protocols work
more or less bu accident using lite circuits (start with IOS 11.3).
IPX will not work because DLSw converts all IPX ARPA frame (ethernet
type 2 with type code) into SNAP frames before forwarding them
to the remote peer. The remote peer doesn't know about that and happily
forwards a SNAP frame onto the ethernet.
So the only change you have is to configure ALL IPX stations to use
either SNAP or SAP encapsulation (but please the SAME on both sides).
But even with that - performance will suck and I can't guarantee that
there isn't some other catch.
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Ronnie
Royston
Sent: 07 December 2000 02:08
To: ccielab@groupstudy.com
Subject: DLSW and IPX
I have 4 routers set up on my desk, the 2 middle ones have 2 enet interfaces
and the end routers have one enet interface.
R1--------R2--------R3--------R4
I set up DLSW enet-to-enet between R2 and R3 using crb, routing ip and
bridging everything else. The only communication I can establish across
DLSw is IPX with sap encapsulation. Nothing else will ping. Has anyone
else noticed this?
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:26:01 GMT-3