From: mark salmon (masalmon@xxxxxxxxx)
Date: Wed Oct 25 2000 - 15:17:20 GMT-3
I beg to differ. I have tried to use the clock rate command on an
interface with a DE cable and got an error message about wrong cable
type. Have you been able to successfully configure a clock rate on a
DTE cabled interface.
Allyn Baskerville wrote:
>
> There are two "types" of DCE interfaces. One is defined by the cable that is
> attached to the router, and the other is by the interface type required by
> the encapsulation. For example, two routers connected back-to-back
> configured for frame relay require "frame-relay intf-type dce" on one end
> and a "frame-relay intf-type dte" on the other. This has nothing to do with
> the physical cable connection and consequently clocking. So you can specify
Mark Salmon
Network Support Engineer - SBC OP HQ
Cisco Systems Inc
8735 W. Higgins Road Suite 300
Chicago IL 60631
Phone:773-695-8235
Pager:800-365-4578
email: masalmon@cisco.com
Empowering The Internet Generation.
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:30 GMT-3