From: Daniel Keller (DMKeller@xxxxxxxxxxxx)
Date: Mon Oct 23 2000 - 23:36:44 GMT-3
Need to add the appletalk local-routing global config command on R1.
DK
>>> Hazel Gachoka <hgachoka@cisco.com> 10/23/00 08:59PM >>>
I have a hub and spoke config where r1 is the hub and r3 and r5 are spokes. I a
m running Appletalk EIGRP on FR and have disabled appletalk eigrp split-horizio
n on the hub router. The spokes however do not see each other as neighbors. I h
ave configured frame-realy map stmts for appletalk. Can anyone see what I am mi
ssing?
Hazel
r1
appletalk routing eigrp 1
appletalk route-redistribution
interface Serial0.2 multipoint
ip address 137.20.32.1 255.255.255.0
ip access-group 101 in
no ip directed-broadcast
ip ospf network point-to-multipoint
ip ospf interface-retry 0
decnet cost 10
appletalk cable-range 32-32 32.1
appletalk zone fr
appletalk protocol eigrp
no appletalk protocol rtmp
no appletalk eigrp-splithorizon
ipx network 135
no ipx split-horizon eigrp 1
frame-relay map ip 137.20.32.3 103 broadcast
frame-relay map ip 137.20.32.5 105 broadcast
frame-relay map appletalk 32.3 103 broadcast
frame-relay map appletalk 32.5 105 broadcast
r1#sh app neigh
AppleTalk neighbors:
48.2 Serial0.1, uptime 00:35:59, 39 secs
NOTE: Neighbor is down.
32.3 Serial0.2, uptime 00:34:48, 30 secs
Neighbor is reachable as a EIGRP peer
32.5 Serial0.2, uptime 00:35:35, 13 secs
Neighbor is reachable as a EIGRP peer
r1#sh fram map
Serial0.2 (up): appletalk 32.3 dlci 103(0x67,0x1870), static,
broadcast,
CISCO, status defined, active
Serial0.2 (up): appletalk 32.5 dlci 105(0x69,0x1890), static,
broadcast,
CISCO, status defined, active
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:29 GMT-3