From: Hazel Gachoka (hgachoka@xxxxxxxxx)
Date: Mon Oct 23 2000 - 23:38:56 GMT-3
That did it,
Thanks much!!!!
Hazel
At 09:36 PM 10/23/00 -0500, Daniel Keller wrote:
>Need to add the appletalk local-routing global config command on R1.
>
>DK
>
>>>> Hazel Gachoka <hgachoka@cisco.com> 10/23/00 08:59PM >>>
>I have a hub and spoke config where r1 is the hub and r3 and r5 are spokes. I
am running Appletalk EIGRP on FR and have disabled appletalk eigrp split-horizi
on on the hub router. The spokes however do not see each other as neighbors. I
have configured frame-realy map stmts for appletalk. Can anyone see what I am m
issing?
>
>Hazel
>
>r1
>appletalk routing eigrp 1
>appletalk route-redistribution
>interface Serial0.2 multipoint
> ip address 137.20.32.1 255.255.255.0
> ip access-group 101 in
> no ip directed-broadcast
> ip ospf network point-to-multipoint
> ip ospf interface-retry 0
> decnet cost 10
> appletalk cable-range 32-32 32.1
> appletalk zone fr
> appletalk protocol eigrp
> no appletalk protocol rtmp
> no appletalk eigrp-splithorizon
> ipx network 135
> no ipx split-horizon eigrp 1
> frame-relay map ip 137.20.32.3 103 broadcast
> frame-relay map ip 137.20.32.5 105 broadcast
> frame-relay map appletalk 32.3 103 broadcast
> frame-relay map appletalk 32.5 105 broadcast
>
>r1#sh app neigh
>AppleTalk neighbors:
> 48.2 Serial0.1, uptime 00:35:59, 39 secs
> NOTE: Neighbor is down.
> 32.3 Serial0.2, uptime 00:34:48, 30 secs
> Neighbor is reachable as a EIGRP peer
> 32.5 Serial0.2, uptime 00:35:35, 13 secs
> Neighbor is reachable as a EIGRP peer
>r1#sh fram map
>Serial0.2 (up): appletalk 32.3 dlci 103(0x67,0x1870), static,
> broadcast,
> CISCO, status defined, active
>Serial0.2 (up): appletalk 32.5 dlci 105(0x69,0x1890), static,
> broadcast,
> CISCO, status defined, active
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:25:29 GMT-3