From: Timur.Mirza@xxxxxxxxxxxxxxxxxx
Date: Thu Aug 24 2000 - 13:14:42 GMT-3
that's fine, but what if there is a restriction on cfg floating statics? timur
"ccbkck" <kck@ccbzj.com> on 08/24/2000 09:03:25 AM
Please respond to "ccbkck" <kck@ccbzj.com>
To: "khalid siddiq" <khalidsi@hotmail.com>, ccielab@groupstudy.com
cc: (bcc: Timur Mirza/Corporate/AirTouch)
Subject: Re: dialer watch-list
u should use float static routes to the watched network.
look at http://www.cisco.com/warp/public/793/access_dial/backupwatch.html
> hi all,
> i am facing some problem with the dialer watch-list,
> my router detect that the watch network is down but unable to dial,
> i am attaching the configuration.
> any comment is appriciated.
>
> router 1:
>
>
> interface Async4
> ip address 10.60.0.2 255.255.0.0
> encapsulation ppp
> bandwidth 33
> dialer in-band
> dialer map ip 2.0.0.0 broadcast 7774267
> dialer map ip 3.3.0.0 name pdn 7774267
> dialer map ip 10.60.0.1 broadcast 7774267
> dialer watch-group 1
> dialer-group 1
> async mode dedicated
> no peer default ip address
> no cdp enable
> ppp pap sent-username khalid password 7 05000E0E2D454A02
>
>
> router eigrp 1
> redistribute static
> network 10.0.0.0
>
>
> access-list 101 deny eigrp any any log
> access-list 101 permit ip any any log
>
>
> dialer watch-list 1 ip 3.3.0.0 255.255.0.0
> dialer watch-list 1 ip 2.0.0.0 255.0.0.0
>
> dialer-list 1 protocol ip list 101
>
>
>
> sh ip route is ,
> router#sh ip route
> Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP
> D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area
> N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2
> E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP
> i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, * - candidate
> default
> U - per-user static route, o - ODR
>
> Gateway of last resort is 0.0.0.0 to network 0.0.0.0
>
> D 2.0.0.0/8 [90/10639872] via 10.3.0.17, 00:00:20, Serial1
> 3.0.0.0/16 is subnetted, 1 subnets
> D 3.3.0.0 [90/10639872] via 10.3.0.17, 00:00:05, Serial1
> 203.135.1.0/30 is subnetted, 1 subnets
> C 203.135.1.232 is directly connected, Serial0
> 10.0.0.0/8 is variably subnetted, 5 subnets, 3 masks
> D 10.0.0.0/16 [90/10537472] via 10.3.0.17, 22:10:30, Serial1
> C 10.1.0.0/16 is directly connected, Ethernet0
> C 10.3.0.16/30 is directly connected, Serial1
> C 10.60.0.0/16 is directly connected, Async4
> S 10.60.0.1/32 is directly connected, Async4
> S* 0.0.0.0/0 is directly connected, Serial0
>
>
> and when the route 2.0.0.0 and 3.3.0.0 is removed.
>
> Aug 24 13:01:00.161: Dialer Watch: watch-group = 1
> Aug 24 13:01:00.161: network 3.3.0.0/255.255.0.0 DOWN,
> Aug 24 13:01:00.165: network 2.0.0.0/255.0.0.0 UP,
> Aug 24 13:01:00.169: primary UP
> Aug 24 13:01:01.253: Dialer Watch: watch-group = 1
> Aug 24 13:01:01.253: network 3.3.0.0/255.255.0.0 DOWN,
> Aug 24 13:01:01.257: network 2.0.0.0/255.0.0.0 UP,
> Aug 24 13:01:01.257: primary UP
> Aug 24 13:01:23.555: Dialer Watch: watch-group = 1
> Aug 24 13:01:23.555: network 3.3.0.0/255.255.0.0 DOWN,
> Aug 24 13:01:23.559: network 2.0.0.0/255.0.0.0 DOWN,
> Aug 24 13:01:23.559: primary DOWN
> Aug 24 13:01:23.563: Dialer Watch: Dial Reason: Primary of group 1 down
> Aug 24 13:01:23.563: Dialer Watch: watch-group = 1,
> Aug 24 13:01:24.575: Dialer Watch: watch-group = 1
> Aug 24 13:01:24.575: network 3.3.0.0/255.255.0.0 DOWN,
> Aug 24 13:01:24.579: network 2.0.0.0/255.0.0.0 DOWN,
> Aug 24 13:01:24.579: primary DOWN
> Aug 24 13:01:24.579: Dialer Watch: Dial Reason: Primary of group 1 down
> Aug 24 13:01:24.583: Dialer Watch: watch-group = 1,
>
> no dialing ????
> but when i ping 10.60.0.1,
> 1#ping 10.60.0.1
>
> Type escape sequence to abort.
> Sending 5, 100-byte ICMP Echos to 10.60.0.1, timeout is 2 seconds:
>
> Aug 24 13:12:33.782: Async4: Dialing cause ip (s=10.60.0.2, d=10.60.0.1)
> Aug 24 13:12:33.782: Async4: Attempting to dial 7774267
> Aug 24 13:12:33.782: CHAT4: Attempting async line dialer script
> Aug 24 13:12:33.786: CHAT4: no matching chat script found for 7774267
> Aug 24 13:12:33.786: CHAT4: Dialing using Modem script:
> d0efault-d0ials0cript &
> System script: none
> Aug 24 13:12:33.798: CHAT4: process started
> Aug 24 13:12:33.798: CHAT4: Asserting DTR
> Aug 24 13:12:33.802: CHAT4: Chat script d0efault-d0ials0cript started.....
> Success rate is 0 percent (0/5)
> NETS1#
> Aug 24 13:12:52.850: CHAT4: Chat script d0efault-d0ials0cript finished,
> status =
> Success
> Aug 24 13:12:52.858: As4 IPCP: Install route to 10.60.0.1
> Aug 24 18:12:54.854: %LINK-3-UPDOWN: Interface Async4, changed state to up
> Aug 24 13:12:54.886: As4 PPP: Treating connection as a callout
> Aug 24 13:12:54.886: As4 PPP: Phase is ESTABLISHING, Active Open
> Aug 24 13:12:54.890: As4 LCP: O CONFREQ [Closed] id 177 len 20
> Aug 24 13:12:54.894: As4 LCP: ACCM 0x000A0000 (0x0206000A0000)
> Aug 24 13:12:54.894: As4 LCP: MagicNumber 0x210C8DD7 (0x0506210C8DD7)
> Aug 24 13:12:54.898: As4 LCP: PFC (0x0702)
> Aug 24 13:12:54.898: As4 LCP: ACFC (0x0802)
> Aug 24 13:12:55.078: As4 LCP: I CONFREQ [REQsent] id 9 len 24
> Aug 24 13:12:55.082: As4 LCP: ACCM 0x000A0000 (0x0206000A0000)
> Aug 24 13:12:55.082: As4 LCP: AuthProto PAP (0x0304C023)
> Aug 24 13:12:55.086: As4 LCP: MagicNumber 0x04563C71 (0x050604563C71)
> Aug 24 13:12:55.090: As4 LCP: PFC (0x0702)
> Aug 24 13:12:55.126: As4 LCP: PFC (0x0702)
> Aug 24 13:12:55.130: As4 LCP: ACFC (0x0802)
> Aug 24 13:12:55.130: As4 LCP: State is Open
> Aug 24 13:12:55.134: As4 PPP: Phase is AUTHENTICATING, by the peer
> Aug 24 13:12:55.138: As4 PAP: O AUTH-REQ id 2 len 19 from "khalid"
> Aug 24 13:12:55.266: As4 PAP: I AUTH-ACK id 2 len 5
> Aug 24 13:12:55.266: As4 PPP: Phase is UP
> Aug 24 13:12:55.270: As4 IPCP: O CONFREQ [Closed] id 102 len 10
> Aug 24 13:12:55.274: As4 IPCP: Address 10.60.0.2 (0x03060A3C0002)
> Aug 24 13:12:55.290: As4 IPCP: I CONFREQ [REQsent] id 40 len 10
> Aug 24 13:12:55.294: As4 IPCP: Address 10.60.0.1 (0x03060A3C0001)
> Aug 24 13:12:55.294: As4 IPCP: O CONFNAK [REQsent] id 40 len 10
> Aug 24 13:12:55.298: As4 IPCP: Address 2.0.0.0 (0x030602000000)
> Aug 24 13:12:55.526: As4 IPCP: I CONFACK [REQsent] id 102 len 10
> Aug 24 13:12:55.530: As4 IPCP: Address 10.60.0.2 (0x03060A3C0002)
> Aug 24 13:12:55.530: As4 IPCP: I CONFREQ [ACKrcvd] id 41 len 4
> Aug 24 13:12:55.534: As4 IPCP: O CONFACK [ACKrcvd] id 41 len 4
> Aug 24 13:12:55.538: As4 IPCP: State is Open
> Aug 24 13:12:56.290: dialer Protocol up for As4
> Aug 24 13:12:56.294: As4 IPCP: Remove route to 10.60.0.1
> Aug 24 18:12:56.334: %LINEPROTO-5-UPDOWN: Line protocol on Interface Async4,
> cha
> nged state to up
> Aug 24 13:12:56.358: As4 IPCP: Install route to 2.0.0.0
>
> regards,
> khalid
>
>
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:29 GMT-3