RE: about EIGRP in point to multipoint frame-relay network

From: Geatti (geatti@xxxxxxxx)
Date: Sun Aug 06 2000 - 10:19:24 GMT-3

• Next message: damien: "OSPF Filtering/ Policying etc"
• Previous message: zhuoyun Wu: "about EIGRP in point to multipoint frame-relay network"
• Maybe in reply to: zhuoyun Wu: "about EIGRP in point to multipoint frame-relay network"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

   
   Split horizon is OFF ON PHYSICAL interfaces by default on Frame Relay
   and ON WITH SUBINTERFACES. You may want to try a 'no split-horizon
   eigrp (as #)' at the physical frame-relay interface of routerA. You
   can always enable split-horizon at the spokes so that loops will be
   prevented.
   Hope this works for you.
   Marco
   
   -----Original Message-----
   From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
   zhuoyun Wu
   Sent: Sunday, August 06, 2000 2:42 AM
   To: ccielab@groupstudy.com
   Subject: about EIGRP in point to multipoint frame-relay network
   
   I have three Router are connected by point to multipoint frame-relay,
   i setup two PVC, A to B and A to C. I can get the right route when i
   run rip, igrp &ospf, but B cannot get route of C and C cannot get
   route of B when i run EIGRP, i'm sure that Split-horizon is disable.
   who can tell me why ?
   
   
   
   IOS Version 11.2(22a)
   
   
   
   Thanks!
   
   

• Next message: damien: "OSPF Filtering/ Policying etc"
• Previous message: zhuoyun Wu: "about EIGRP in point to multipoint frame-relay network"
• Maybe in reply to: zhuoyun Wu: "about EIGRP in point to multipoint frame-relay network"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:24:21 GMT-3