From: Daniel Beynon (dbeynon@xxxxxxxxxxx)
Date: Fri Jul 14 2000 - 16:35:30 GMT-3
you should issue the following commands to ensure
the ports are in the forwarding Action. Also the
counters should be increasing TX and RX.
Also ensure IP routing is off in the R1 and R2
routers.
Sh bridge:
Router>sh bridge
Total of 300 station blocks, 295 free
Codes: P - permanent, S - self
Bridge Group 1:
Address Action Interface Age RX count TX count
00e0.1ed1.94c8 forward Ethernet0 0 2638 28
0060.3efa.99eb forward Serial0 0 6090 256
0060.3efa.99ec forward Ethernet0 0 7170 1245
00e0.1ed1.9470 forward Ethernet0 0 4545 1567
00e0.1ed1.9472 forward Serial0 5 1 0
Also issue a SHOW SPAN
Hope that helps
Dan
>From: Boaz Ri <boaz_ids@yahoo.com>
>Reply-To: Boaz Ri <boaz_ids@yahoo.com>
>To: ccielab@groupstudy.com
>Subject: Transparent Bridging config
>Date: Fri, 14 Jul 2000 10:00:49 -0700 (PDT)
>
>Hello all,
>
>Been working thru bridging configs and was wondering
>if someone has an idea why its not working properly.
>
>configuration
>
>PC1(TokenRing)--TR---(R1)--Serial---(R2)--TR--PC2(TokenRing)
>
>Here is a summary of config for R1 and R2
>
>R1
>bridge 1 protocol ieee
>interface serial 0
>bridge-group 1
>interface TokenRing 0
>bridge-group 1
>
>R2
>bridge 1 protocol ieee
>interface serial 0
>bridge-group 1
>interface TokenRing 0
>bridge-group 1
>
>PC1 - Ip address 172.16.1.1/24
>PC2 - Ip address 172.16.1.2/24
>
>I tried pinging from PC1 to PC2 but no response. I
>turned off IP routing on both R1 and R2 so IP should
>be bridged across. Its not working..
>
>Need feedback!
>
>Regards,
>
>Boaz
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:53 GMT-3