DLSW+

From: peter brown (pita40@xxxxxxxxxxx)
Date: Sat May 20 2000 - 11:46:41 GMT-3

• Next message: David Goldsmith: "Re: DLSW+"
• Previous message: Muthu Mohanasundaram: "Re: ISDN DDR for IPX"
• Next in thread: Earl Aboytes: "Re: DLSW+"
• Maybe reply: Earl Aboytes: "Re: DLSW+"
• Maybe reply: Greenjeepp@xxxxxxx: "Re: DLSW+"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

My router has enterprise image loaded. When I tried to configure DLSW+ I
receive invalid input error under the DLSW+. What does this mean. Is there a
command to enable DLSW+ that I am missing. Here is my config & error message

Router>en
Router#config t
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)#dlsw local-peer peer-id 172.16.24.2
                ^
% Invalid input detected at '^' marker.

Router(config)#

Global
dlsw local-peer peer-id 172.16.24.2
dlsw remote-peer 0 tcp 172.16.40.2
dlsw bridge-group 1
bridge 1 protocol ieee

interface
bridge-group 1

Is there a particular sequence to enter this config. This is the config in
Caslow's book. Please help

• Next message: David Goldsmith: "Re: DLSW+"
• Previous message: Muthu Mohanasundaram: "Re: ISDN DDR for IPX"
• Next in thread: Earl Aboytes: "Re: DLSW+"
• Maybe reply: Earl Aboytes: "Re: DLSW+"
• Maybe reply: Greenjeepp@xxxxxxx: "Re: DLSW+"
• Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:30 GMT-3