From: Earl Aboytes (earl@xxxxxxxxxxxx)
Date: Sat May 20 2000 - 14:54:40 GMT-3
I would suspect that your image is not actually the enterprise version. It may
be named like it is the enterprise image, but may not actually be that image.
Do you have another router that you know dlsw is working? Maybe you could tft
p it over to that router. Make sure your not violating any license agreements
that you have with Cisco if you do that.
Earl
---------- Original Message ----------------------------------
From: David Goldsmith <dgoldsmi@cisco.com>
Reply-To: David Goldsmith <dgoldsmi@cisco.com>
Date: Sat, 20 May 2000 11:15:39 -0400
>Peter,
>
>Can you send a show version.
>
>Dave
>
>
>
>
>peter brown wrote:
>
>> My router has enterprise image loaded. When I tried to configure DLSW+ I
>> receive invalid input error under the DLSW+. What does this mean. Is there a
>> command to enable DLSW+ that I am missing. Here is my config & error message
>>
>> Router>en
>> Router#config t
>> Enter configuration commands, one per line. End with CNTL/Z.
>> Router(config)#dlsw local-peer peer-id 172.16.24.2
>> ^
>> % Invalid input detected at '^' marker.
>>
>> Router(config)#
>>
>> Global
>> dlsw local-peer peer-id 172.16.24.2
>> dlsw remote-peer 0 tcp 172.16.40.2
>> dlsw bridge-group 1
>> bridge 1 protocol ieee
>>
>> interface
>> bridge-group 1
>>
>> Is there a particular sequence to enter this config. This is the config in
>> Caslow's book. Please help
>>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:30 GMT-3