From: Bill Dicks (wdicks@xxxxxxxxxxxxxxxxxx)
Date: Fri May 19 2000 - 16:45:59 GMT-3
There is a problem matching the address list...the distribute-list reads it
as matching all..you need to specify 0.0.0.0 0.0.0.0 - where the wildcards
indicate match ALL bits. IT may interpret 0.0.0.0 as 0.0.0.0
255.255.255.255 - which is all/anything.
Bill Dicks
Structure Technologies, Inc
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of Kevin
Young
Sent: Friday, May 19, 2000 9:40 AM
To: ccielab
Subject: distribute-list
Hi,guys, i met a problem as below:
redistributing a default route(0.0.0.0/0)from ospf into eigrp, when use
route-map, it works fine, only redistribute one route(0.0.0.0/0) into eigrp:
router eigrp 10
redistribute ospf 100 route-map a
network 11.0.0.0
default-metric 64 1000 255 1 1500
access-list 1 permit 0.0.0.0
route-map a permit 10
match ip address 1
when use distribute-list, it doesn't work fine, redsitributed all
routes(included 0.0.0.0/0) into eigep:
router eigrp 10
redistribute ospf 100
network 11.0.0.0
default-metric 64 1000 255 1 1500
distribute-list 1 out ospf 100
access-list 1 permit 0.0.0.0
but when use distribute-list 1 out interface , it also works fine, i'm
puzzled, why it doesn't work using distribute-list 1 out ospf 100 ? what
about extended access-list?
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:30 GMT-3