From: Li Chaoyong (hughcyli@xxxxxxxxxxxxxxxxx)
Date: Fri Apr 21 2000 - 10:19:54 GMT-3
Do you means "DIALER REMOTE-NAME" , it is p2p
----- Original Message -----
From: "Stanley Seow" <stanley_seow@techno-craft.com.sg>
To: <ccielab@groupstudy.com>
Sent: Friday, April 21, 2000 3:14 PM
Subject: RE: ISDN Dialer profile with dialer map ip command
> For dialer profile, it is like point to point..so the dialer map statement
> is not needed... you just point to the specific layer 2 address...in your
> case would be the telephone number... just like putting
>
> frame-relay interface-dlci XXX in a point to point FR interface...
>
> SO the physical dialer interface is point to multipoint whereas the Dialer
> profile is point to point... ( relating back to Frame Relay conditions )
>
> Stanley
>
> > -----Original Message-----
> > From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
> > Kruepke
> > Sent: Friday, April 21, 2000 6:06 AM
> > To: ccielab@groupstudy.com
> > Cc: tok cok
> > Subject: Re: ISDN Dialer profile with dialer map ip command
> >
> >
> > I found the same thing. I can't explain the "why" of the
> > behavior, but I think I was able to figure out the "how."
> >
> > The weird thing is that even though you are using a dialer
> > interface, you can still use legacy DDR. If you use the 'dialer
> > map ip' command, you should get the same results as if you were
> > using that same command on a physical interface. This seems
> > weird to me anyway.
> >
> > However, if you enter the other dialer profile commands (the ones
> > that the Caslow book says you have to use), then the 'dialer ?'
> > command will no longer show 'map' as an option. I think if you
> > enter 'dialer remote-string', it will take the 'map' option away.
> > (If not that command, it is one of the dialer profile
> > commands...) Then you are doing what would be expected in dialer
> > profiles.
> >
> > So, yes, in my experience it works. Whether there are any
> > caveats to doing it either way, I'm not sure.
> >
> > Keith
> >
> > ----- Original Message -----
> > From: "tok cok" <tokcok@hotmail.com>
> > To: <ccielab@groupstudy.com>
> > Sent: Wednesday, April 19, 2000 8:59 PM
> > Subject: ISDN Dialer profile with dialer map ip command
> >
> >
> > Hi all,
> >
> > I was reading Bruce Calsow's book on ISDN dialer profile.
> > In his book, he said that when using Dialer profile, "dialer map
> > ip" command
> > is not available. The only time we use "dialer map ip command"
> > is on DDR.
> > But when I create a dialer interface and do a "show dialer ?", the map
> > parameter is available.
> >
> > Can any help me on this. My question is, can dialer profile also
> > use dialer
> > map ip command to map next hop ip address?
> >
> > Thanks all.
> >
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:15 GMT-3