From: Li Chaoyong (hughcyli@xxxxxxxxxxxxxxxxx)
Date: Thu Apr 20 2000 - 11:38:25 GMT-3
1st Question, you could create a BVI in 3600, use BRIDGE to integrate the
ATM link. C5K use ethernet ARP and CLIP use nsap mapping, these are
different L3->L2 AR protocol, So use BVI to create BRIDGE and construct a
symmetric Address Resolution model.
3600 BVI <--bridge--> ATM CLIP <--bridge-->C5K<--SWITCH--> Ethernet End
Device
2nd. LS1010 's management interface can be configured an IP address, it is
very simple CLIP function, can only use to manage the SWITCH. LS1010 can not
route IP packet.
----- Original Message -----
From: "Kenneth Kriel" <kkriel@netscape.net>
To: <ccielab@groupstudy.com>
Sent: Thursday, April 20, 2000 8:45 PM
Subject: ATM CLIP ->LS1010 -> LANE
>
> Ladies and Gentleman,
>
> My mind tells me that question (1) is impossible, but experience has
taught
> me not to be so cynical, I hope that someone could answer the following
two
> questions :
>
> 1. CLIP on 3600 --> LS1010 --> C5K LANE
> Is it possible to test my CLIP config by doing a ping to the C5K int sc0
> with a PVC (aal5snap) config on the LANE module ? Is there another way ?
>
>
> 2. CLIP on 3600 --> LS1010
> Is there a way to configure CLIP on the LS1010 ? If so how ? any
suggestions
> ?
>
> I am trying to test and verify my CLIP config on the 3600 but have nothing
> to ping.
>
>
> Ken
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:14 GMT-3