Connecting a Token ring port to a MAU

From: Aaron DuShey (adushey@xxxxxxxxx)
Date: Tue Apr 18 2000 - 20:18:50 GMT-3

Next message: Nnanna Obuba: "Re: How to filter NETBIOS in DLSW PEER"
Previous message: Rahmlow, Howard F.: "RE: Question 'bout CCIE Lab format"
Next in thread: Derek Small (Fuse): "Re: Connecting a Token ring port to a MAU"
Maybe reply: Derek Small (Fuse): "Re: Connecting a Token ring port to a MAU"
Maybe reply: Scott Morris: "RE: Connecting a Token ring port to a MAU"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This is probably a stupid question but here goes-
I have a MAU and am connecting 2 Cisco routers to it. They are the only
devices connected to it. I cannot get the interface up it says
%LINK-3-UPDOWN: Interface TokenRing0/0, changed state to down
%LINK-5-CHANGED: Interface TokenRing0/0, changed state to initializing
%TR-3-OPENFAIL: Unit 0, open failed: Lobe Test, failed
%LINK-3-UPDOWN: Interface TokenRing0/0, changed state to down
%LINK-5-CHANGED: Interface TokenRing0/0, changed state to initializing
any ideas?
thanks,,

Aaron DuShey-

Next message: Nnanna Obuba: "Re: How to filter NETBIOS in DLSW PEER"
Previous message: Rahmlow, Howard F.: "RE: Question 'bout CCIE Lab format"
Next in thread: Derek Small (Fuse): "Re: Connecting a Token ring port to a MAU"
Maybe reply: Derek Small (Fuse): "Re: Connecting a Token ring port to a MAU"
Maybe reply: Scott Morris: "RE: Connecting a Token ring port to a MAU"
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ] [ attachment ]

This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:14 GMT-3