From: Scott Morris (smorris@xxxxxxxx)
Date: Mon Apr 17 2000 - 21:38:31 GMT-3
Check to make sure the speeds match on the two routers. Also make sure (if
you're setting them to 16 meg) that the MAU is capable of that speed!
Scott Morris, MCSE, CNE(3.x), CCDP (R&S), CCIE (R&S) #4713, Security
Specialization, CCNA - WAN Switching
smorris@ccci.com
----------------------------------------------------------------------------
------------------------------
Chesapeake Network Solutions http://www.ccci.com
Cell Phone: 941-350-8590 e-mail:smorris@ccci.com
Pager: 800-490-1326 Fax: 606-225-8403
-----Original Message-----
From: nobody@groupstudy.com [mailto:nobody@groupstudy.com]On Behalf Of
Aaron DuShey
Sent: Tuesday, April 18, 2000 7:19 PM
To: CCIE (E-mail)
Subject: Connecting a Token ring port to a MAU
This is probably a stupid question but here goes-
I have a MAU and am connecting 2 Cisco routers to it. They are the only
devices connected to it. I cannot get the interface up it says
%LINK-3-UPDOWN: Interface TokenRing0/0, changed state to down
%LINK-5-CHANGED: Interface TokenRing0/0, changed state to initializing
%TR-3-OPENFAIL: Unit 0, open failed: Lobe Test, failed
%LINK-3-UPDOWN: Interface TokenRing0/0, changed state to down
%LINK-5-CHANGED: Interface TokenRing0/0, changed state to initializing
any ideas?
thanks,,
Aaron DuShey-
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:14 GMT-3