From: Jay Chandradas (jay@xxxxxxxxxxx)
Date: Sat Apr 15 2000 - 16:51:12 GMT-3
Netbios traffic can be filtered by NETBIOS name and Byte-count. These
access list does not have an access list numbers. You will define,
config)# netbios access-list host XYZ deny/permit < netbios name >
These access-list are applied at the dlsw remote-peer statement. You may
have , dlsw remote-peer 0 tcp <ip address > host-netbios-out XYZ
lasp-output-list are used for filtering by logical-link control layer
addresses.
Thanks
regards
Jay.
-----Original Message-----
From: Li Chaoyong
To: ccielab@groupstudy.com
Sent: 4/15/00 4:15 AM
Subject: How to filter NETBIOS in DLSW PEER
I want to know how to configure DLSW peers to allow NETBIOS only.
Use lsap-output-list ?
Please help me.
-----------------------
Another Question
In this condition
R1----------R2
R1 and R2 is runing APPLETALK EIGRP. How to filter EIGRP APPLETALK
ROUTE?
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:23:14 GMT-3