From: John Galt Kupec (jkupec2@xxxxxxxxxx)
Date: Mon Jan 17 2000 - 21:06:42 GMT-3
Denton Bobeldyk wrote:
>
> Clarification:
> I'm looking to use the dlsw remote-peer command with an lsap
> filter. I want to allow only SNA traffic from one peer to another
> and would like to know where on the CD I could find this type
> code information.. Thank You.
Well, the "Configuring Source-Route Bridging" docs give some information
but I suspect you're looking for a detailed listing of various
type codes? I seem to recall that, when I was on a similar search a
while back, the older docs (11.2-ish) were more informative than the
11.3 and up docs, but I may just not have been looking in the right
place. Anyway, here are a couple URL's I saved from the Open Forum
on CCO that may help:
http://www.cisco.com/openf/faqfiles/5881.html
http://www.cisco.com/openf/faqfiles/1116.html
I think you need a CCO login to access.
-- John Galt Kupec CCIE #4837 Chesapeake Network Solutions, Inc. jkupec@ccci.com http://www.ccci.com ----------------------------------------------------------------------
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:22:45 GMT-3