From: Richard Marti (sandy_123@xxxxxxxxxxx)
Date: Fri Jan 07 2000 - 00:40:00 GMT-3
Hello,
I have the following questions:
1.I have been reading confusing information about "ip ospf demand-circuit".
Do you need the statement on both the ends of the BRI interfaces (Calling &
called) or one end ONLY?. Has anyone tested with both options. Feedback will
be appreciated.
2.for IGRP when i configure 'IP DEFAULT-NETWORK 130.10.0.0" i can see in my
routing table with "* 150.100.0.0/24 is subnetted, 1 subnets" (that is
candidate route). However, I do not see " i" infront of the route( as
mentioned by Caslow on page 356).Also,I do not see any thing as set as my
"Gateway of last resort". FYI, the network defined is available in RB's
routing table.
setup :
ospf IGRP
RA-------serial---RB--------Token
Thank You
Richard
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:22:43 GMT-3