From: Eric Zarling (EZARLING@xxxxxxxxxxx)
Date: Tue Dec 21 1999 - 12:53:01 GMT-3
Try debugging on ppp negotiation and ppp authentication.
Eric Zarling CCNP
Systems Engineer
IKON Technology Services
(414)577-6600
ezarling@mis-usc.com
>>> Stanley Freiman <stanley@tml.co.za> 12/20/99 10:34PM >>>
What version of IOS are you using ? I have had similar problems with dialer
profiles on 11.3 using primary rate to dial out, 11.2 works perfectly.
Brian Best wrote:
> Hello all. Have a few questions regarding multiple dialer profiles with a
> single bri inferface.
>
> I have a two routers each with a single bri interface. I have set up the
> routers so that only one dials the connection - only one is configured with
> a dialer string. I have no problem with one dialer interface - works just
> fine. I had problems when I add the second interface using a different
> protocol with the appropriate dialer-list command in each dialer interface.
>
> If I ping the interface comes up and immediately disconnects several times
> in succession. I have check debug q931, debug dialer, debug ppp auth, etc.
> All show the line connecting successfully and then show the connection being
> terminated normally.
>
> Is there a limitation using multiple dialer profiles with the same bri when
> you are not using one of the profiles for backup interface purposes? Any
> advice would be greatly appreciated.
>
> Thanks.
>
> Brian Best
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:59 GMT-3