From: Brian Best (bbest@xxxxxxxxxxxxx)
Date: Mon Dec 20 1999 - 22:50:33 GMT-3
Hello all. Have a few questions regarding multiple dialer profiles with a
single bri inferface.
I have a two routers each with a single bri interface. I have set up the
routers so that only one dials the connection - only one is configured with
a dialer string. I have no problem with one dialer interface - works just
fine. I had problems when I add the second interface using a different
protocol with the appropriate dialer-list command in each dialer interface.
If I ping the interface comes up and immediately disconnects several times
in succession. I have check debug q931, debug dialer, debug ppp auth, etc.
All show the line connecting successfully and then show the connection being
terminated normally.
Is there a limitation using multiple dialer profiles with the same bri when
you are not using one of the profiles for backup interface purposes? Any
advice would be greatly appreciated.
Thanks.
Brian Best
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:59 GMT-3