From: Denton Bobeldyk (denny@xxxxxxxxxxxxxx)
Date: Wed Sep 15 1999 - 13:36:24 GMT-3
I have a configuration with a hub and spoke scenario over
an X.25 cloud where the 2 spokes are using a single subinterface point
to point connection to the hub which is using 2 point to point
subinterfaces to connect to each of the spokes.
When I run IPX rip I can see all the routes fine.
When I run NLSP, all of the routes show up fine except
for the other spoke's network connection to the hub
I can ipx ping across the network fine, but for some
reason i can't see the other spoke's network connection
through the X.25 cloud. I can see my own connection (of course,
because I'm directly connected to it) and I can ipx ping through
the other one, but I can't see the ipx route for his X.25 wan
connection.
Any ideas? IP OSPF routes all show up fine using the same configuration
as well as IPX rip routes if I disable NLSP.
-Denny
-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-*-
Denton Bobeldyk MCNE, CCDA, CCNA, CCSI
Email: denny@kentwoodps.org
Phone: 616-530-9196
Master CNE - Connectivity
Cisco Certified Design Associate
Cisco Certified Network Associate
Cisco Certified Systems Instructor
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:50 GMT-3