From: Derek Fage (DerekF@xxxxxxxxxxx)
Date: Tue Aug 31 1999 - 11:32:07 GMT-3
I'm running through some Voice scenarios, and have a few issues.
Setting up the actual voice stuff with pots and voip dial peers is simple
enough, but I'm having some problems with the RSVP/WFQ/Traffic shaping.
One configuration I'm looking is setup as follows (bear in mind that this is
all on paper - no voice kit available 8-(
Phone -- FXS -- R1 (2600) -- Ethernet -- R2 (2500) -- Frame -- R3 (2600) --
FXS -- Phone
The frame connection is 64k with a 32k CIR
I have the followign questions:
1. On the R1 E0 what values should I put into the rsvp bandwidth command ?
Should this match up with the values on the frame interfaces, or does it not
matter
2. On the R2 E0 I am again unsure what to put in the rsvp bandwidth command
3. On the F/R interfaces I need to know what rsvp bandwidth to use, and how
to decide what to use for traffic-shape parameters and fair-queue
parameters. Also, should these parameters be set on the physical F/R
interface, on the point-to-point subinterface, or on both ?
Cheers,
Derek...
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:48 GMT-3