From: Derek Fage (DerekF@xxxxxxxxxxx)
Date: Tue Aug 31 1999 - 13:33:28 GMT-3
Thanks,
I'm not really expecting it on the lab, but I'd like to undertand it (as it
will be eventually). As for ATM...........
So if I have a CIR of 32k and are using G.11, should I use the parameters 32
8, or a lower initial number ? Would I do the same on all interfaces along
the path ?
Derek...
> -----Original Message-----
> From: Jason Aarons [SMTP:jaarons@hotmail.com]
> Sent: 31 August 1999 17:08
> To: DerekF@itexjsy.com
> Cc: ccielab@groupstudy.com
> Subject: Re: VOIP Questions
>
> I don't belive VOIP/RSVP will be in the lab, but I could see Traffic
> Shapping etc.
>
> Your RSVP bandwidth would be the amount you want to "try" to RSVP. So if
> you run g711 it would be approx 8K per phone call. So if you had 2 FXS
> cards you might want to RSVP 16K, etc.
>
> I can't see the lab having RSVP though, if it did the point value should
> be
> low..
>
>
> ----Original Message Follows----
> From: Derek Fage <DerekF@itexjsy.com>
> Reply-To: Derek Fage <DerekF@itexjsy.com>
> To: ccielab@groupstudy.com
> Subject: VOIP Questions
> Date: Tue, 31 Aug 1999 15:32:07 +0100
>
> I'm running through some Voice scenarios, and have a few issues.
>
> Setting up the actual voice stuff with pots and voip dial peers is simple
> enough, but I'm having some problems with the RSVP/WFQ/Traffic shaping.
>
> One configuration I'm looking is setup as follows (bear in mind that this
> is
> all on paper - no voice kit available 8-(
>
> Phone -- FXS -- R1 (2600) -- Ethernet -- R2 (2500) -- Frame -- R3 (2600)
> --
> FXS -- Phone
>
> The frame connection is 64k with a 32k CIR
>
> I have the followign questions:
>
> 1. On the R1 E0 what values should I put into the rsvp bandwidth command ?
> Should this match up with the values on the frame interfaces, or does it
> not
> matter
>
> 2. On the R2 E0 I am again unsure what to put in the rsvp bandwidth
> command
>
> 3. On the F/R interfaces I need to know what rsvp bandwidth to use, and
> how
> to decide what to use for traffic-shape parameters and fair-queue
> parameters. Also, should these parameters be set on the physical F/R
> interface, on the point-to-point subinterface, or on both ?
>
> Cheers,
>
> Derek...
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:48 GMT-3