From: David Powers (DPowers@xxxxxxxxxxxxxx)
Date: Tue Jun 22 1999 - 20:53:31 GMT-3
honestly, I don't know why you need to do both. You may not have to.
Dave
-----Original Message-----
From: Brian Van Benschoten [mailto:vader@inxpress.net]
Sent: Tuesday, June 22, 1999 4:32 PM
To: Ben Rife; ccielab@groupstudy.com
Subject: Re: AUX Port
I had to do it on both routers.
below is my config
interface Async8
ip address 1.1.1.1 255.255.255.0
encapsulation ppp
async default routing
async mode dedicated
line 8
modem InOut
transport input all
stopbits 1
rxspeed 38400
txspeed 38400
flowcontrol hardware
----- Original Message -----
From: Ben Rife <brife@bignet.net>
To: Brian Van Benschoten <vader@inxpress.net>; <ccielab@groupstudy.com>
Sent: Tuesday, June 22, 1999 6:22 PM
Subject: Re: AUX Port
> Guys,
>
> I have tried to do a shut/no shut on the async intf but it doesn't
help.
I'm
> about to burn my routers and file an insurance claim.
>
> Please Help.
>
> Ben
>
>
> ----- Original Message -----
> From: Brian Van Benschoten <vader@inxpress.net>
> To: <ccielab@groupstudy.com>
> Sent: Tuesday, June 22, 1999 6:58 PM
> Subject: Re: AUX Port
>
>
> > why do I need both the async default routing and the async dynamic
routing
> ?
> > Why not just the default routing command.
> >
> > someone asked a question regarding the flopping of the async
interface
> after
> > a reboot. I have that happening on a 4700 router. The only way i
found
> > around it is to do a shut / no shut on the async interface.
> >
> > ----- Original Message -----
> > From: David Powers <DPowers@westechinc.com>
> > To: <ccielab@groupstudy.com>
> > Sent: Tuesday, June 22, 1999 3:57 PM
> > Subject: RE: AUX Port
> >
> >
> > > Yes you can and here are some things you need to do it.
> > > async default routing
> > > async dynamic routing
> > > async mode dedicated
> > >
> > > after this it should behave as a regular interface
> > >
> > > -----Original Message-----
> > > From: Ben Rife [mailto:brife@bignet.net]
> > > Sent: Tuesday, June 22, 1999 12:35 PM
> > > To: ccielab@groupstudy.com
> > > Subject: AUX Port
> > >
> > >
> > > Hi guys,
> > >
> > > I am wondering how to configure the aux 0 ports on my routers for
> > > connectivity between two routers. I understand that I can route
over
> > > those ports. Can you give me some configs?
> > >
> > > Thanks,
> > >
> > > Benjy Rife
> > > MCSE, CNE, CCIE Candidate
> > > brife@bignet.net
> > > www.bignet.net/~brife
> > >
> >
>
This archive was generated by hypermail 2.1.4 : Thu Jun 13 2002 - 08:21:39 GMT-3