Re: Cisco 2700 Series Fa 10Full forced with Juniper EX4200

2700 ???
I know 2500 10Mbps are only half, some 4000/4500 10Mbps are only half
too. May be your case too :)

I remember making a full duplex hybrid by using 2 of them, one to tx and
one to rx :) There use to be a command to splice the logical
interface into two phys !

-Carlos

Juan Faure @ 25/07/2014 02:50 -0300 dixit:
> Hi Guys,
>
> Maybe this will be a bit "off topic" question, but for sure many of you
> will know about.
>
> I have a 2700 Cisco Series router, with the in-board Ethernet interface
> stablished to 100-Full Dzplex, and need to connect with a Juniper EX4200
> Switch, using a 10/100/1000 interface.
>
> Despite i am using the righ junos commands to fix sped and link type to
> full dzplex, the link does not come up. If i leave the juniper interface
> without these settings, link comes up (but obviously on half dzplex)....
>
> Unfortunately, Cisco Router is from the Telephony operator, i can not touch
> it directly.
>
> Anybode had some trouble like this, trying to connect cisco with juniper
> with fixed speed&duplex settings? i have seen some forums where somebody
> suggest that it is not an uncommon problem.
>
> Best Regards
>
>
> --
> Juan Faure
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
>
>
>
>
>

-- 
Carlos G Mendioroz  <tron_at_huapi.ba.ar>  LW7 EQI  Argentina
Blogs and organic groups at http://www.ccie.net