Re: GRE Tunnels Issue

Shiran,

Tunnel bandwidth command is not limiting the traffic. It is used for
satellite connections with Rate Based Satellite Control Protocol.

See the command reference:
http://www.cisco.com/en/US/docs/ios-xml/ios/interface/command/ir-t2.html#wp4185130494

Regards,
Piotr

On 11/4/13 4:56 PM, shiran guez wrote:
> Default GRE tunnel bandwidth is limited, you can set your needed bandwidth
> according to your need with the following command under the GRE tunnel
> "tunnel bandwidth <bandwidth>"
>
> Note: do not mistake that command with the "bandwidth <num>" as that
> command is used for administrative purpose and the "tunnel bandwidth
> <bandwidth>" is effecting data path capability.
>
>
> On Mon, Nov 4, 2013 at 5:03 PM, sulman naseer <n_sulman_at_hotmail.com> wrote:
>
>> Dear Group,
>>
>> In need help in my implementation scenario like
>> We are implementing P2P GRE Tunnels from Head Office to Our Branches(20
>> Branches) over MPLS VPN Cloud.
>> For test purpose, we implement P2P GRE tunnel in ip mode from Head office
>> with 2 branches but after that we are facing slow internet browsing
>> issue(But not very slow). From Branch end Client to Head office Data
>> Center, Ping response are very good but browsing is very slow. As we route
>> traffic through MPLS cloud again mean shutdown GRE Tunnels then internet
>> browsing better then before.
>> As i think may be the MTU issues with GRE but not sure. So need guidance
>> to resolve this issue permanently.
>>
>> Note: In HO we have Cisco Nexus 7k and in Branches we have Cisco 3750e
>> Switches.
>>
>> Thanks
>>
>>
>> Blogs and organic groups at http://www.ccie.net
>>
>> _______________________________________________________________________
>> Subscription information may be found at:
>> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Mon Nov 04 2013 - 20:48:03 ART