Re: poe issue

Try
test cable-diagnostics tdr int <inteface>

On Thu, Aug 15, 2013 at 5:55 AM, Imran Ali <immrccie_at_gmail.com> wrote:

> is it any thing that low end models work with cat5 and high end with cat
> 6?
>
>
> On Wed, Aug 14, 2013 at 8:57 PM, Karl Young <kaelwyoung_at_netscape.net>
> wrote:
>
> > Imran,
> > Check the Cat 5 cable ! you might have a bad drop.
> > Karl.
> >
> >
> > ----Original Message-----
> > From: Imran Ali <immrccie_at_gmail.com>
> > To: Cisco certification <ccielab_at_groupstudy.com>
> > Sent: Wed, Aug 14, 2013 1:31 pm
> > Subject: poe issue
> >
> > Guys
> >
> > if i take my 7945 ip phone to switch room and connect it . its
> > getting poe and registering fine .
> >
> > but when i go out to cubicle where user is sitting and connect it over
> > to same port . (cable patched by patch pannel ) .. their is no poe.
> >
> > when i connect 7912 .. smaller ip phone ..it get poe from the
> cubicle
> > . This is strange .
> >
> > both phones has different poe needs ? it is depondent on cable cat
> 5, 6
> > etc ?
> >
> > is their any way to boost up poe from the switchport ?
> >
> >
> > i tried some options
> >
> > power inline auto ....
> > shut no shut
> > reload switch ...
> >
> >
> > Blogs and organic groups at http://www.ccie.net
> >
> > _______________________________________________________________________
> > Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html
>
>
> Blogs and organic groups at http://www.ccie.net
>
> _______________________________________________________________________
> Subscription information may be found at:
> http://www.groupstudy.com/list/CCIELab.html

Blogs and organic groups at http://www.ccie.net
Received on Fri Aug 16 2013 - 00:34:37 ART