RE: ipv6 neighbors not seen while i have ospfv3 neighbors

"show ipv6 neighbors" shows the ICMPv6 Neighbor Discovery (ND) cache, and is the equivalent of "show ip arp" for IPv4. Does ARP or ND run over Frame Relay?

Brian McGahan, CCIE #8593 (R&S/SP/Security)
bmcgahan_at_INE.com

Internetwork Expert, Inc.
http://www.INE.com

-----Original Message-----
From: nobody_at_groupstudy.com [mailto:nobody_at_groupstudy.com] On Behalf Of rakesh madupu
Sent: Monday, December 31, 2012 7:41 AM
To: Cisco certification
Subject: ipv6 neighbors not seen while i have ospfv3 neighbors

Hello,

I have the below output

R6#show ipv6 nei
R6#show ipv6 ospf nei

            OSPFv3 Router with ID (6.6.6.6) (Process ID 1)

Neighbor ID Pri State Dead Time Interface ID Interface
4.4.4.4 0 FULL/ - 00:00:35 15
Serial1/0.64

Is this expected over FR point-to-point interface, I tried to ping to see if that helps but no luck

Am i Missing something ?

Thank you

--
Any Fool can Know The Point is to Understand - Einstein
www.cciematrix.com
Blogs and organic groups at http://www.ccie.net